mist1010-board
UzixLS
10x10cm PCB variant of MIST FPGA project for G738/G706 enclosure
Components (80)
| Reference | Value | Description |
|---|---|---|
| Q1,Q3,Q4,Q6,Q7 | BC817 | |
| Q2 | IRLML6402 | -3.7A Id, -20V Vds, 65mOhm Rds, P-Channel HEXFET Power MOSFET, SOT-23 |
| Q5 | BC856 | |
| U1 | MT48LC16M16A2 | |
| U2 | AT91SAM7S256-AU | |
| U3 | EP3C25E144 | |
| U4 | MAX3421E | |
| U5 | FE2.1-CQFP48A | |
| U6 | ATtiny45-20SU | |
| U7 | DS1307Z+ | |
| U8,U12 | LD1117AS33TR | 1A 20V Fixed LDO Linear Regulator, 3.3V, SOT-89/SOT-223/TO-220/TO-252/TO-263 |
| U9 | LD1117AS12TR | |
| U10 | LD1117AS25TR | |
| U11 | H11L1SM | |
| U13 | 74AHCT1G125DB | Single Buffer Gate Tri-State, Low-Voltage CMOS |
| U14 | ESP-12E | 802.11 b/g/n Wi-Fi Module |
| U15 | MAX809LEUR | |
| U16 | 74LVC2G34DB | |
| U17 | LP2985-3.3 | 150mA 16V Low-noise Low-dropout Regulator With Shutdown, 3.3V output voltage, SOT-23-5 |
| BT1 | 1775485-1 or S8401-46 | Multiple-cell battery |
| C1 | 2.2u | |
| C2,C9 | 1n | |
| C3-C5,C22-C24,C29-C32,C36-C38,C43-C49,C53-C62,C64-C67,C71-C73,C75,C92 | 100n | |
| C6,C15,C16 | 10p | |
| C7,C8,C27,C28 | 15p | |
| C10 | 10n | |
| C11,C12,C39,C40,C80,C87,C89 | 100u | |
| C13,C14,C82,C83 | 2.2n | |
| C17-C19,C25,C26,C33,C34,C74,C79,C84-C86,C88,C90 | 10u | |
| C20,C21 | 100p | |
| C35,C42,C50-C52,C63,C70,L1-L3 | 1u | |
| C41,C68,C69,C81,C91 | 22u | |
| C77,C78 | 300p | |
| D1 | LED_Red | |
| D2 | LED_Yellow | |
| D3 | LED_Green | |
| D4,D5 | 1N4148W | 75V 0.15A Fast Switching Diode, SOD-123,Diode |
| F1 | 1.1A | |
| F2 | 0.2A | |
| H1-H4 | Screw M3 dk=5mm L=4mm | |
| J1,J3,J13,J14,J21 | Conn_02x05_Odd_Even | Generic connector, double row, 02x05, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| J2 | USB_B_Micro | |
| J4 | PJ-320 | Audio Jack, 4 Poles (TRRS) |
| J5-J8 | USB_A | USB Type A connector |
| J9 | DB15_Female_HighDensity_MountingHoles | 15-pin female receptacle socket D-SUB connector, High density (3 columns), Triple Row, Generic, VGA-connector, Mounting Hole |
| J10 | TE 041021-4 | |
| J11,J19,J20 | PJ392 | |
| J12,J15 | Conn_01x04 | |
| J16 | MEM2055-00-190-01-A | Micro SD Card Socket with two card detection pins |
| J17 | B2B-XH-A | Generic connector, single row, 01x02, script generated |
| J22 | XHP-2, SXH-002T-P0.6 | Generic connector, single row, 01x02, script generated |
| JP1 | Jumper_2_Open | |
| JP2 | Jumper | Jumper, 2-pole, small symbol, open |
| L5,L6 | 6.8u | Inductor |
| N1 | G738 or G706 | |
| R1,R8,R24,R49 | 1.5k | |
| R2-R4,R9,R38,R44,R52,R55,R59,R66,R67,R73-R75,R89,R100,R109-R111 | 10k | |
| R5,R6,R12-R14,R27,R29,R30,R54,R56,R57 | 22 | |
| R7 | 120 | |
| R10,R11,R99,R104 | 560 | |
| R15,R22,R33,R76,R83,R101 | 1k | |
| R16,R17,R23,R25,R34,R35,R77,R78,R84,R85 | 1.1k | |
| R18,R26,R37,R79,R86 | 2.2k | |
| R19,R28,R39,R80,R87 | 4.3k | |
| R20,R31,R40,R81,R88 | 9.1k | |
| R21,R32,R41,R82,R90 | 18k | |
| R36 | 2.7k 1% | |
| R42,R43 | 100 | |
| R45-R47,R106-R108 | 220 | Resistor |
| R48,R50,R51,R53,R60-R64,R68-R72 | 4.7k | |
| R58 | 470k | |
| R65 | 470 | |
| R102 | 680 | |
| SW1 | PB05A | Single Pole Single Throw (SPST) switch |
| SW2 | SW_DIP_x02 | |
| SW3-SW5 | SW_Push | |
| X1 | 27 MHz | |
| X2 | 12 MHz | |
| Y1 | 18.432 MHz | Four pin crystal, GND on pins 2 and 4 |
| Y2 | 32768 Hz |