shell-bms
anshinx
shell-eco-marathon pehlivan team bms
Components (69)
| Reference | Value | Description |
|---|---|---|
| Q1 | NPN | Bipolar transistor symbol for simulation only, substrate tied to the emitter |
| Q2,Q3,Q8-Q11 | BUK7M27-80EX | N-MOSFET transistor, drain/source/gate |
| Q4-Q7 | BC817 | 0.8A Ic, 45V Vce, NPN Transistor, SOT-23 |
| U1 | BQ76952PFBR | |
| U2 | LM5017MR | 600mA, 100V Step-Down Switching Regulator, PowerSO-8 |
| U3 | STM32G431C8Tx | STMicroelectronics Arm Cortex-M4 MCU, 64KB flash, 32KB RAM, 170 MHz, 1.71-3.6V, 38 GPIO, LQFP48 |
| U4 | AP2204K-5.0 | 150mA low dropout linear regulator, wide input voltage range, 5.0V fixed positive output, SOT-23-5 |
| U6 | XC6206 - 3V3 | Positive 60-250mA Low Dropout Regulator, Fixed Output, SOT-23 |
| U7 | ESP-WROOM-02 | Wi-Fi Module, ESP8266EX SoC, 32-bit, 802.11b/g/n, WPA/WPA2, 2.7-3.6V, SMD |
| U8 | TJA1051T | High-Speed CAN Transceiver, silent mode, SOIC-8 |
| U9 | CH340K | USB serial converter, UART, SSOP-10 |
| BZ1 | Buzzer | Buzzer, polarized |
| C1-C17 | 220nF | Unpolarized capacitor |
| C18-C20 | 10nf | Unpolarized capacitor |
| C21 | 100pf | Unpolarized capacitor |
| C22,C26,C27,C33,C38,C39,C49 | 1uF | Unpolarized capacitor |
| C23 | 0.470uF | Unpolarized capacitor |
| C24,C29,C30 | 0.1uF | Unpolarized capacitor |
| C25 | 100pF | Unpolarized capacitor |
| C28 | 22nF | Unpolarized capacitor |
| C32,C42-C44,C47,C48,C50,C52,C54,C55,C58,C60-C63 | 100nF | Unpolarized capacitor |
| C34 | .1uF | Unpolarized capacitor |
| C35 | 15nF | Unpolarized capacitor |
| C36 | 3.3nF | Unpolarized capacitor |
| C40,C41 | 2.2uF | Unpolarized capacitor |
| C45,C46,C53,C59,C64 | 10uF | Unpolarized capacitor |
| C51 | 10uf | Unpolarized capacitor |
| C56,C57 | 22pF | Unpolarized capacitor |
| C65 | 100nf | Unpolarized capacitor |
| D1 | D | Diode |
| D2 | 1N914 | 100V 0.3A Small Signal Fast Switching Diode, DO-35 |
| D3,D4 | 16V Zener | Zener diode |
| D5,D7,D8 | 1N4148 | 100V 0.15A standard switching diode, DO-35 |
| D6 | LED_R | Light emitting diode |
| FB1 | 12R | Ferrite bead |
| J1 | Conn_01x09 | Generic connector, single row, 01x09, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J2 | Conn_01x20 | Generic connector, single row, 01x20, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J3,J4,J9 | Conn_01x04 | Generic connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J5,J11 | USB_C_Receptacle_USB2.0_16P | USB 2.0-only 16P Type-C Receptacle connector |
| J6-J8 | Conn_01x02 | Generic connector, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J13 | OUTSIDE LED | Generic connector, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| L1 | 220uH 2A | Inductor |
| MP1 | BAT+ | |
| MP2 | BAT- | |
| MP3 | PACK+ | |
| MP4 | PACK- | |
| R1-R17 | 22 | Resistor |
| R18-R21,R47,R48 | 0R | Resistor |
| R22,R26,R27 | 100R | Resistor |
| R23,R24,R51,R56,R58 | 1K | Resistor |
| R25,R31,R37,R39,R60,R73 | 47 | |
| R28,R29 | 10k | Resistor |
| R30 | 300 | Resistor |
| R32,R38 | 1M | Resistor |
| R33-R36 | 5.1k | Resistor |
| R42,R49,R70,R71 | 5.1K | Resistor |
| R43 | 100K | Resistor |
| R44 | 86.6K | Resistor |
| R45,R55,R62-R67 | 10K | Resistor |
| R46 | 46k | Resistor |
| R50 | 120R | Resistor |
| R52,R57,R59 | 4.7K | Resistor |
| R53,R54,R72 | 260 | Resistor |
| R61 | 1m | Resistor |
| R68,R69 | 22R | Resistor |
| SW1 | SW_Push | Push button switch, generic, two pins |
| SW2 | SW_Nidec_CAS-120A1 | Switch, single pole double throw |
| TP1 | TestPoint | test point |
| Y1 | 8MHz | Two pin crystal |