Loading design…
| Reference | Value | Description |
|---|---|---|
| Q3 | DMP2070UQ-7 | P-MOSFET transistor, drain/source/gate |
| U1 | 2MB Flash | FLASH - NOR Memory IC 16Mbit SPI - Quad 1/0 133 MHz 7 ns 8-USON (2x3) |
| U2 | AP2112K-3.3 | 600mA low dropout linear regulator, with enable pin, 3.8V-6V input voltage range, 3.3V fixed positive output, SOT-23-5 |
| U3 | MCP73831-2-OT | Single cell, Li-Ion/Li-Po charge management controller, 4.20V, Tri-State Status Output, in SOT23-5 package |
| U4 | RFM95W-915S2 | Low power long range transceiver module, SPI and parallel interface, 915 MHz, spreading factor 6 to12, bandwidth 7.8 to 500kHz, -111 to -148 dBm, SMD-16, DIP-16 |
| U6 | AP3602AKTR-G1 | Diodes Incorporated |
| U7 | BME688 | Gas, Humidity, Pressure, Temperature Sensor I²C, SPI Output |
| U8 | INA260 | Current Monitor Regulator High/Low-Side 10mA 16-TSSOP |
| U9 | RFM96W-433S2 | Low power long range transceiver module, SPI and parallel interface, 433 MHz, spreading factor 6 to12, bandwidth 7.8 to 500kHz, -111 to -148 dBm, SMD-16, DIP-16 |
| U10 | PMSA003I | PM1.0 PM2.5 PM10 SENSOR PMSA003I |
| AE1 | Antenna 915 | Antenna |
| AE2 | Antenna 433 | RF ANT 433MHZ WHIP STR CAB PAN |
| C1,C3,C5,C6,C8,C9,C13,C16,C17 | 10uF | 10 uF 10% 16V Ceramic Capacitor X5R 0805 (2012 Metric) |
| C2,C4 | 22pF | 22 pF 10% 16V Ceramic Capacitor COG, NPO 0603 (1608 Metric) |
| C7,C10-C12,C14,C15,C18,C19 | 1uF | 1 uF 10% 16V Ceramic Capacitor X7R 0603 (1608 Metric) |
| CHG1 | ORANGE | Light emitting diode |
| D1 | WS2812B3535 | NeoPixel Mini 3535 RGB LEDs w/ Integrated Driver Chip - Black |
| D2,D3 | 1N4148 | DIODE GEN PURP 75V 150MA SOD323 |
| D4 | MBR120 | Diode 20 V 1A Surface Mount SOD-123FL |
| J1,J4 | Conn_Coaxial_Small | small coaxial connector (BNC, SMA, SMB, SMC, Cinch/RCA, LEMO, ...) |
| J2 | JSTPH | Connector Header Surface Mount, Right Angle 2 position 0.079" (2.00mm) |
| J3 | Conn_02x05_Odd_Even Female | CONN RCPT 10POS 0.05 GOLD SMD |
| J5 | Conn_02x05_Odd_Even Male | Generic connector, double row, 02x05, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| J8 | MEM2075-00-140-01-A | uSD card socket |
| L1 | RED | Light emitting diode |
| L2 | 10uH | 10 H Unshielded Wirewound Inductor 235 mA 190mOhm 1007 (2518 Metric) |
| MCU1 | ATSAMD51J19A-A | SAM D51 Microchip SMART ARM Cortex-M4F-based MCU, 512K Flash, 192K SRAM, TQFP-64 |
| R1,R3-R6,R8,R20,R23,R30-R32,R34,R36,R40,R44 | 10K | 10 kOhms 1% 0.125W, 1/8W Chip Resistor 0603 (1608 Metric) Anti-Sulfur Thin Film |
| R2 | 1K | 1 kOhms $1% 0.125W, 1/8W Chip Resistor 0603 (1608 Metric) Anti-Sulfur Thin Film |
| R7 | 2.2K | 2.2 kOhms ±1% 0.2W, 1/5W Chip Resistor 0603 (1608 Metric) Automotive AEC-Q200 Thick Film |
| R9 | 4x 100K | 4 resistor network, parallel topology, SIP package, split |
| R10-R19,R21,R22,R24-R28,R33,R35,R37,R39,R41-R43,R45-R47 | 0 | Resistor |
| R38 | 100K | Resistor |
| SW1 | KMR2 | Push button switch, generic, two pins |
| TP1 | VBUS Testpoint | test point |
| TP2 | Batt Testpoint | test point |
| TP3 | D+ Testpoint | test point |
| TP4 | D- TestPoint | test point |
| TP5 | 5V Testpoint | test point |
| TP6 | GND Testpoint | test point |
| TP7 | 3V3 Testpoint | test point |
| X2 | 32.768 kHz | Two pin crystal |
| X3 | microUSB 2.0 B | USB - micro B USB 2.0 Receptacle Connector 5 Position Surface Mount, Right Angle. |