Loading design…
kristofkatzenberger
| Reference | Value | Description |
|---|---|---|
| IC1 | AP33772SDKZ-13-FA01 | USB, Type-C Controller PMIC W-QFN4040-24 (Type A1) |
| IC2 | LP5910-1.8DRVR | 300-mA low-noise low-IQ low-dropout (LDO) linear regulator |
| IC3 | BMI270 | IMUs - Inertial Measurement Units Smart Ultra-Low Power Inertial Measurement Unit (IMU) for Wearable Applications |
| Q1,Q2 | DMN3008SFG | 17.6A Id, 30V Vds, N-Channel Power MOSFET, 4.4mOhm Ron, 86nC Qg (typ), PowerDI3333-8 |
| U1 | BQ25628ERYKR | |
| U2 | TPS63805YFFR | |
| U3 | ESP32-S3-WROOM-1 | RF Module, ESP32-S3 SoC, Wi-Fi 802.11b/g/n, Bluetooth, BLE, 32-bit, 3.3V, onboard antenna, SMD |
| U4-U12 | DPS368 | Digital Barometric Pressure Sensor for Portable Devices |
| U13 | BMM350 | |
| U14 | TCA9548APWR | Low voltage 8-channel I2C switch with reset, TSSOP-24 |
| C1,C4,C7,C9,C12 | 10uF | Unpolarized capacitor |
| C2,C5,C6,C11,C19,C21-C41,C43-C45,C47 | 100nF | Unpolarized capacitor |
| C3,C15-C17,C20,C46 | 1uF | Unpolarized capacitor |
| C8,C14,C18 | 22uF | Unpolarized capacitor |
| C10 | 47nF | Unpolarized capacitor |
| C13 | 4.7uF | Unpolarized capacitor |
| C42 | 2.2uF | Unpolarized capacitor |
| D1 | LED WHITE | Light emitting diode |
| D2 | LED RED | Light emitting diode |
| D3,D4 | LESD5D5.0CT1G | Transient Voltage Suppressors for ESD Protection |
| J1 | USB_C_Receptacle_USB2.0_16P | USB 2.0-only 16P Type-C Receptacle connector |
| J3,J5,J6 | Conn_01x02_Pin | Generic connector, single row, 01x02, script generated |
| J4 | Conn_01x03_Pin | Generic connector, single row, 01x03, script generated |
| J7 | SM13B-GHS-TB | |
| L1 | 470nH | Inductor |
| L2 | 1uH | Inductor |
| R1 | 6,2k | Resistor |
| R2 | 100 | Resistor |
| R3 | 5m | Resistor |
| R4,R5 | 5.1k | Resistor |
| R6,R7,R10,R17,R32,R39-R44 | 10k | Resistor |
| R8 | 30.1k | Resistor |
| R9 | 5.23k | Resistor |
| R11 | 511k | Resistor |
| R12 | 1.5k | Resistor |
| R14 | 91k | Resistor |
| R15,R16,R22-R31 | 4.7k | Resistor |
| R18-R21 | 100k | Resistor |
| R33-R38 | 50 | Resistor |
| TF1 | TF-012 | Card Connection Mode:Push-Push Card Type:MicroSD Card (TF Card) Connector Type:Connector and Ejector Height Above Board:2mm Operating Temperature:-25°C~+85°C Operating Temperature:-25°C~+85°C |
| TH1 | SDNT1608X103F3950FTF | Temperature dependent resistor, negative temperature coefficient |