Loading design…
rohamid
PCB controller backpack for east rising LCD modules
| Reference | Value | Description |
|---|---|---|
| Q1 | DMG2301L | -3A Id, -20V Vds, P-Channel MOSFET, SOT-23 |
| Q2-Q4 | MMBT3904 | 0.2A Ic, 40V Vce, Small Signal NPN Transistor, SOT-23 |
| U1 | MAX98357A | Mono DAC with amplifier, I2S, PCM, TDM, 32-bit, 96khz, 3.2W, TQFP-16 |
| U2 | TPS61169 | Synchronous Boost Regulator, Adjustable Output up to 28V, 400 mA Switch Current Limit, SOT-23-5 |
| U3 | XPT2046TS | Single-supply, 12bit, 4 ch, touch screen driver, 2.2 - 5.25 VDD, -40 to +85 C, QSPI, SPI, 3-wire serial interface, TSSOP-16 |
| U4 | CAT24C256 | 256 kb CMOS Serial EEPROM, DIP-8/SOIC-8/TSSOP-8/DFN-8 |
| U5 |
| 1A Low Dropout regulator, positive, 3.3V fixed output, SOT-223 |
| U6 | siplex-som-s16 |
|---|
| BT2 | S8411-45R |
|---|
| BZ1 | MLT-9650 | Buzzer, polarized |
|---|
| C1,C5,C7,C11,C19 | 10u | Unpolarized capacitor |
|---|
| C2,C3,C10,C22 | 1u | Unpolarized capacitor |
|---|
| C4,C6,C9,C12-C18,C20,C23 | 100n | Unpolarized capacitor,Unpolarized capacitor, small symbol |
|---|
| C8 | 4u7 | Unpolarized capacitor |
|---|
| C21 | 22uF | Polarized capacitor |
|---|
| D1 | NSR0320MW2T1G | Diode |
|---|
| D2,D12 | MBR0540 | 40V 0.5A Schottky Power Rectifier Diode, SOD-123 |
|---|
| D3-D5 | LED | Light emitting diode |
|---|
| D6-D9 | MMSZ5226BT1G | Zener diode |
|---|
| D10,D11 | BAT54S | Vr 30V, If 200mA, Dual schottky barrier diode, in series, SOT-323 |
|---|
| FB1 | 600R/100MHz | Ferrite bead, small symbol |
|---|
| J1 | SWD | Generic connector, double row, 02x07, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J2 | Conn_01x40_MountingPin | Generic connectable mounting pin connector, single row, 01x40, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J3 | Micro_SD_Card_Det1 | Micro SD Card Socket with one card detection pin |
|---|
| J4 | USB_C_Receptacle_USB2.0_16P | USB 2.0-only 16P Type-C Receptacle connector |
|---|
| J6 | Serial | Generic connectable mounting pin connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J8 | Conn_01x02_MountingPin | Generic connectable mounting pin connector, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J9,J10 | Conn_01x10_MountingPin | Generic connectable mounting pin connector, single row, 01x10, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| L1 | 6.8u | Inductor, small symbol |
|---|
| R1,R4,R7,R8,R12-R15,R22,R25,R27,R29-R31 | 10K | Resistor, small symbol |
|---|
| R2 | 4.7R | Resistor, small symbol |
|---|
| R3,R11,R16 | 2K | Resistor, small symbol |
|---|
| R5,R6,R17-R21 | 2K2 | Resistor, small symbol |
|---|
| R9,R10 | 5K1 | Resistor, small symbol |
|---|
| R24,R26,R28 | 1K | Resistor, small symbol |
|---|
| R32 | 100K | Resistor, small symbol |
|---|
| R33 | 1M | Resistor, small symbol |
|---|
| RN1-RN7 | 100 | 4 resistor network, parallel topology |
|---|
| SW1 | BOOT0 | Push button switch, generic, two pins |
|---|
| SW2 | RST | Push button switch, generic, two pins |
|---|
| TP1-TP7 | TestPoint | test point |
|---|