Loading design…
sarahemm
LED display showing the current status of the CERN accelerator complex
| Reference | Value | Description |
|---|---|---|
| Q1 | MMBT5551L | 0.6A Ic, 160V Vce, NPN Transistor, SOT-23 |
| U1 | PIC32MX130F064D-IPT | 32-bit Microcontrollers (64KB Flash and 16KB SRAM TQFP-44) with Audio and Graphics Interfaces, USB, and Advanced Analog |
| U2,U6 | AP62300TWU | 3A, 750kHz Buck DC/DC Converter, PFM for light load efficiency, 4.2V-18V input voltage, 0.8V-7V adjustable output voltage, TSOT-23-6 |
| U3-U5 | SN74LVC245APW | 8-Bit Single-Supply Bus Transceiver With 5V tolerant input voltage and 3-State Outputs 24mA, TSSOP-20 |
| U7 | AS1115-BSST | 64 LEDs, I2C Interfaced LED Driver with Keyscan, QSOP-24 |
| U8,U9 | TLC5955DCA | 48-Channel, 16-Bit, PWM LED Driver with DC, BC, LED Open-Short Detection, and Internal Current Setting, HTSSOP56 |
| U10 | EA_DOGM128X-6 | EA DOGM128X-6 Graphical Display 128x64 optional backlight SPI 3.0-3.3V |
|---|
| C1,C9,C10 | 10uF | Unpolarized capacitor |
|---|
| C2-C8,C13-C16 | 0.1uF | Unpolarized capacitor |
|---|
| C11,C12,C28,C29 | 22uF | Unpolarized capacitor |
|---|
| C17-C25 | 1uF | Unpolarized capacitor |
|---|
| C26,C27 | 47pF | Unpolarized capacitor |
|---|
| CN1 | Link In | RJ connector, 8P8C (8 positions 8 connected), RJ31/RJ32/RJ33/RJ34/RJ35/RJ41/RJ45/RJ49/RJ61, Shielded |
|---|
| CN2 | ICSP | Microchip PIC In-Circuit Serial Programming/Debugging (ICSP/ICD) connector |
|---|
| DSP1 | Accel Mode Left |
|---|
| DSP2 | Accel Mode Right |
|---|
| DSP3 | Beam Mode Left |
|---|
| DSP4 | Beam Mode Right |
|---|
| DSP5 | t(SP) Display | 4 digit 7 segment clock type, common anode |
|---|
| DSP6 | Energy MS Digit | One digit 7 segment, common anode |
|---|
| DSP7 | Energy Almost-MS Digit | One digit 7 segment, common anode |
|---|
| DSP8 | Energy Almost-LS Digit | One digit 7 segment, common anode |
|---|
| DSP9 | Energy LS Digit | One digit 7 segment, common anode |
|---|
| L1,L2 | 3.3uF | Inductor |
|---|
| LED1-LED24 | Beam 1 | Light emitting diode |
|---|
| LED25-LED48 | Beam 2 | Light emitting diode |
|---|
| LED49 | Beam 1 Dump | Inolux RGB LED, PLCC-6 |
|---|
| LED50 | Beam 2 Dump | Inolux RGB LED, PLCC-6 |
|---|
| LED51 | IP 1 | Inolux RGB LED, PLCC-6 |
|---|
| LED52 | IP 2 | Inolux RGB LED, PLCC-6 |
|---|
| LED53 | IP 5 | Inolux RGB LED, PLCC-6 |
|---|
| LED54 | IP 8 | Inolux RGB LED, PLCC-6 |
|---|
| LED55,LED56 | Beam 1 Dump Tunnel | Light emitting diode |
|---|
| LED57-LED59 | Beam 1 TI 2 | Light emitting diode |
|---|
| LED60,LED61 | Beam 2 Dump Tunnel | Light emitting diode |
|---|
| LED62-LED64 | Beam 2 TI 8 | Light emitting diode |
|---|
| LED65 | B1 Beam Permit | Dual LED |
|---|
| LED66 | B1 Stable Beams | Dual LED |
|---|
| LED67 | B1 Movables Allowed In | Dual LED |
|---|
| LED68 | Permit Link | Dual LED |
|---|
| LED69 | B2 Beam Permit | Dual LED |
|---|
| LED70 | B2 Stable Beams | Dual LED |
|---|
| LED71 | B2 Movables Allowed In | Dual LED |
|---|
| LED72 | Cryo Status | Dual LED |
|---|
| LED73 | B1 Collimator Status | Dual LED |
|---|
| LED74 | B2 Collimator Status | Dual LED |
|---|
| R1 | 1k | Resistor, US symbol |
|---|
| R2,R8,R10 | 10k | Resistor, US symbol |
|---|
| R3 | 27k | Resistor, US symbol |
|---|
| R4-R6 | 42.2 | Resistor, US symbol |
|---|
| R7 | 5.1k | Resistor, US symbol |
|---|
| R9 | 33.2k | Resistor, US symbol |
|---|
| R11 | 56.2k | Resistor, US symbol |
|---|
| SW1 | Reset | Push button switch, generic, two pins |
|---|
| TP1 | +3.3V | test point |
|---|
| TP2 | +5V | test point |
|---|
| TP3 | GND | test point |
|---|
| TP4 | LINK_I2C_SCL | test point |
|---|
| TP5 | LINK_I2C_SDA | test point |
|---|
| TP6 | LCD_BL_EN | test point |
|---|
| TP7 | LCD_~{RESET} | test point |
|---|
| TP8 | LCD_SCLK | test point |
|---|
| TP9 | LCD_DATA | test point |
|---|
| TP10 | LCD_~{CS} | test point |
|---|
| TP11 | LCD_A0 | test point |
|---|
| TP12 | LED_MCU_SDI | test point |
|---|
| TP13 | LED_MCU_SDO | test point |
|---|
| TP14 | LED_LAT | test point |
|---|
| TP15 | LED_GSCLK | test point |
|---|
| TP16 | LED_SPI_SCLK | test point |
|---|
| TP17 | MTX_~{CE}_A | test point |
|---|
| TP18 | MTX_FLASH | test point |
|---|
| TP19 | MTX_~{RD} | test point |
|---|
| TP20 | MTX_~{RESET} | test point |
|---|
| TP21 | MTX_~{WR} | test point |
|---|
| TP22 | 7SEG_SCL | test point |
|---|
| TP23 | 7SEG_SDA | test point |
|---|
| TP24 | SPI_DATA_BEAM_MISC | test point |
|---|
| TP25 | +15V | test point |
|---|