pcb-dev
sundevilmotorsports
PCB development repository
Components (38)
| Reference | Value | Description |
|---|---|---|
| IC1 | ESP32-S3-WROOM-1-N8R8 | WiFi Modules - 802.11 (Engineering Samples Only) SMD Module, ESP32-S3R8 with 8 MB Octal PSRAM Die, 8 MB Quad SPI flash, PCB Antenna |
| IC3 | TLP175A_TPL,E | MOSFET Output Optocouplers Trigger LED Current 1mA85dC3750 Vrms |
| IC4 | TPS2116DRLR | d |
| IC5 | MIC37100-3.3WS | LDO Voltage Regulators 1.0A Low Voltage uCap LDO Regulator |
| IC6,IC7 | TLC5955RTQT | 48ch, 16bit PWM LED Driver with Dot-Correction, Brightness Control, Open/Short Detection |
| IC8 | BT818Q-T | BT818Q-T, Graphics Controller 60MHz 1920 x 480, 1.024 MB RAM, VQFN |
| IC9 | S25FL256LAGNFB010 | NOR Flash Serial (SPI, Dual SPI, Quad SPI) 3V/3.3V 256M-bit 256M/128M/64M x 1/2-bit/4-bit 8ns Automotive 8-Pin WSON EP Tray |
| IC10 | TPS563211DRLR | Switching Voltage Regulators 4.2-V to 18-V, 3-A, synchronous buck converter with 1% accuracy, PG/SS and PFM/forced-PWM in SOT583 |
| U1 | USBLC6-2SC6 | Very low capacitance ESD protection diode, 2 data-line, SOT-23-6 |
| U2 | SN65HVD230 | CAN Bus Transceivers, 3.3V, 1Mbps, Low-Power capabilities, SOIC-8 |
| U10 | EMIF06-MSD02N16 | |
| BLACK_TP1 | 5006 | Test Point, PC, Snap in Mounting, Compact, Black Base |
| C1,C4,C8,C9,C19-C21,C27 | 1uF | |
| C2,C12,C14 | 10uF | |
| C3,C10,C11,C13,C15-C18,C22 | 100nF | |
| C23,C24,C26 | 22uF | |
| C25 | 47uF | |
| D1 | ESDCAN03-2BWY | ESD Suppressors / TVS Diodes Automotive dual-line Transil, Transient voltage suppressor (TVS) for CAN bus |
| D2,D4 | MBR0540T1G | Guardring for Stress Protection; Very Low Forward Voltage; Epoxy Meets UL94, VO at 1/8"; Package Designed for Optimal Automated Board Assembly Mechanical Characteristics:; Reel Options: 3,000 per 7 inch reel / 8 mm tape; Reel Options: 10,000 per 13 inch reel / 8 mm tape; Device Marking: B4; Polarity Designator: Cathode Band; Weight: 11.7 mg (approximately); Case: Epoxy Molded; Finish: All External Surfaces Corrosion Resistant and Terminal Leads are Readily Solderable; Lead and Mounting Surface Temperature f |
| J1 | USB4730-GF-A | USB 2.0 TYPE C RECEPTACLE, GF, 1 |
| J2 | Conn_01x40_Pin | Generic connector, single row, 01x40, script generated |
| J3 | 19428-0011 | Molex MX150L Series, Series Number 19428, 5.84mm Pitch 4 Way 2 Row Straight PCB Header, Solder Termination, 18A |
| J4 | Molex_1040310811 | |
| L1,L2 | 4.7uH | |
| LED1 | 150060RS75000 | WURTH ELEKTRONIK - 150060RS75000 - LED, 0603, RED, 250MCD, 625NM |
| LED2-LED33 | CLMUD-FKC-CHJNPM569ABB845343 | LED RGB, Common Anode, SMD, 1.5x1.5mm |
| PS1 | TPS61169DCKR | TPS61169 38-V High-Current Boost WLED Driver |
| R1,R5,R10,R11,R15,R31,R54,R57-R60 | 10k | |
| R2,R16 | 5.1k | |
| R3,R4 | 27 | |
| R12 | 120 | |
| R14 | 68 | |
| R34 | 5.05 | |
| R51 | 47K | Resistor, small symbol |
| R55 | 82k | |
| R56 | 11k | |
| S1-S4 | KSS321G_LFS | Tactile Switch SPST-NO Side Actuated Surface Mount, Right Angle SPST-NO 0.05A 50V , -40C ~ 85C |
| TP2 | SMPS | test point |